Screen crash when i close it

(0) Share

Report

Posted on by Community Member

Hello all,

i'm new developing with the SDK and i have the following error, i created a screen with 2 levels (Normal and Detail), when i load data on the grid and then i close the screen, it crash, but when i don't load any data in the grid, i can close it normally, i think that could be an error with the handeler but i'm not sure. i think that the cursors are succesfully create because i can load the data.

*This post is locked for comments

All responses (2)

Answers (0)

Community Member on at

Like (0)

Report

RE: Screen crash when i close it

Thanks for answering, I resolved the problem running the code inspector which show me a message about to correct the format for the name of the form, i´m a little confused about why it crashed for that, it works normally after i corrected
Community Member on at

Like (0)

Report

RE: Screen crash when i close it

Dario,

What version of Dynamics SL are you using? Did you use an extended cursor for the table associated with the grid?

SDK development can be a bit tricky and the simplest of mistakes cause program aborts. The resultant error messages do not always give you a good idea as to where the mistake is. If you want to post the code you are using with this screen I will take a look at it to see if there is something I spot. I have developed over 200 SL screens with the SDK and I still get frustrated from time to time when a new screen fails due to some simple oversight.