web
You’re offline. This is a read only version of the page.
close
Skip to main content

Announcements

No record found.

News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Supply chain | Supply Chain Management, Commerce / Production Performance...
Supply chain | Supply Chain Management, Commerce
Answered

Production Performance Analytics

(2) ShareShare
ReportReport
Posted on by lispyj 201
I am working to enable the Production Performance analytics tiles and cannot get much data to display.  I have refreshed the Production Cube entity store successfully, but the Production Performance page show blanks for all tiles.
 
By default, the Reported as Finished Month Offset and Requirement Date month offset field have filters set.  When I remove the Report as Finished filter, the aggregation tiles (what AX2012 would have called Cues) populate with record counts, summaries, etc. of all production in the system.  I do then receive an query error about too much data.  I have tried to enter other values in those filters without success.
 
Is there some additional entity or other type of action that I need to refresh to get the dates to filter correctly?
 
Thanks,
 
Lisa J
I have the same question (0)
  • Suggested answer
    lispyj Profile Picture
    lispyj 201 on at
    I believe that I have this page active.  For all others with this issue:
    1) Remove the Full Reset batch job and regenerate using the manual refresh.  Look for a 'success' entry in the refresh log.
    2) Go to Organization, Setup, Calendars, Date Dimensions.  Make sure that the Date calendar Start and End Date includes the date ranges you want to display.
    3) Open the Analytics page and check the filters to ensure that the data needed is included.
     
    After these steps I am seeing most of the tiles.  At this point, I believe the empty tiles refer to data that is unused in our system.  
     
     
  • Suggested answer
    lispyj Profile Picture
    lispyj 201 on at
    Posting an add on to this one. 
     
    We had a similar issue with the Warehouse Analytics page.  In that case, the page did not populate because the pdsRebateTable was a part of the view, but we did not have the Rebates table active for our licensing configuration.  To activate rebates, I used the Enable Maintenance mode in LCS and the activated Rebates from the System Administration, Setup, License Configuration, Process Distribution, Rebates.
     
    LJ

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Introducing the 2026 Season 1 community Super Users

Congratulations to our 2026 Super Stars!

Meet the Microsoft Dynamics 365 Contact Center Champions

We are thrilled to have these Champions in our Community!

Congratulations to the March Top 10 Community Leaders

These are the community rock stars!

Leaderboard > Supply chain | Supply Chain Management, Commerce

#1
Mallesh Deshapaga Profile Picture

Mallesh Deshapaga 296

#2
Laurens vd Tang Profile Picture

Laurens vd Tang 234 Super User 2026 Season 1

#3
Syed Haris Shah Profile Picture

Syed Haris Shah 145 Super User 2026 Season 1

Last 30 days Overall leaderboard

Featured topics

Quality order uses default receipt location instead of actual physical receipt location

Product updates

Dynamics 365 release plans