web
You’re offline. This is a read only version of the page.
close
Skip to main content
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Microsoft Dynamics AX (Archived) / production input and o...
Microsoft Dynamics AX (Archived)

production input and output report reg

(0) ShareShare
ReportReport
Posted on by ASHOK.MBA18 347

Dear All,

I have one doubt in production input and output report .

I generated report for particular item, there showing raw material consumption and produced qty.

in output level it showing output qty(fin),output  amount(fin),output qty(phy),output amount(phy)

what is the difference b/w output amount(fin) & output amount (phy)

output_5F00_phy_5F0026005F00_financial.png

.

Thanks

Ashok

*This post is locked for comments

I have the same question (0)
  • Suggested answer
    Fredrik Sætre Profile Picture
    Fredrik Sætre 12,644 on at
    RE: production input and output report reg

    The physical quantity and cost is posted when you "report as finished". The financial quantity is posted when you "Close" a production order.

    The Physical amount is a "guestimated" amount that could be open for changes. So before you "Close" the production order you can post route/job journals and picking lists as you please to make sure all your production costs are taken into account.

    The physical amount can be posted based on estimated or consumed goods at the time. The financial amount is based on what was consumed in the production orders.

    An educated guess would be that: 
    A. You are most likely posting your physical amount based on estimated values.

    B. You are not nearly good enough on posting the right production journals or your estimates are way off.

    Doing Financial recalculation and closing (Which is CRUETIAL if you are using anything else the Standard cost as a costing principle) the amount will be adjusted. 

  • Suggested answer
    Adineh Negahdari Profile Picture
    Adineh Negahdari 807 on at
    RE: production input and output report reg

    Hi,

    As Fredrik explained, output amount(fin) is when you have "Ended" the production order, So the Actual cost is calculated. But output amount (phy) is for the time you have received that QTY in the warehouse by " Report as Finished" and the estimated cost is calculated.

    regards

    Adineh

  • Suggested answer
    Mahmoud Hakim Profile Picture
    Mahmoud Hakim 17,887 on at
    RE: production input and output report reg

    short answer, output amount(fin) for end production order, and output amount (phy) for the report as finished

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

News and Announcements

Join experts in person to explore low code and AI agents at the Power Platform Community Conference sponsored by Microsoft

Quick Links

Responsible AI policies

As AI tools become more common, we’re introducing a Responsible AI Use…

Abhilash Warrier – Community Spotlight

We are honored to recognize Abhilash Warrier as our Community Spotlight honoree for…

Congratulations to the September Top 10 Community Leaders!

These are the community rock stars!

Leaderboard > 🔒一 Microsoft Dynamics AX (Archived)

#1
Martin Tocauer Profile Picture

Martin Tocauer 4

#2
Community Member Profile Picture

Community Member 2

#2
Nayyar Siddiqi Profile Picture

Nayyar Siddiqi 2

Last 30 days Overall leaderboard

Featured topics

Product updates

Dynamics 365 release plans