I am converting from HZN manufacturing to GP 10 manufacturing. I am also using actual costing method. I have entered a MO and one of my components has not been fully issued. When I receive the MO I am not flagged to post a pending pick and when I close the MO I do not receive the message that I have a pending pick. Have I missed a setup somewhere? I would think that I would receive a warning that I have not issued all material to WIP
Thanks to all
*This post is locked for comments
If you go to system preferences for Manufacturing under Manufacturing Order, there are many warnings at the bottom of the window. If using actual costing, it is important to make sure any issues prior to receiving as it will result in incorrect costs. In the MO Receipt window, it does show items issued at the bottom of the window.
Dan Liebl, CMA CPIM | Senior Consultant | OTT,Inc | DLiebl@OTT-inc.com
If you check the Manufacturing Order Preference Defaults window (Tools | Setup | Manufacturing | System Defaults | Manufacturing Orders), you will see a host of options in the "MO Receipt and Close Options" section that you can check.
Two options that might help you here are "Display Low Component Issued Warning" and/or "Display Unused Allocated Material Warning".
David
Stay up to date on forum activity by subscribing. You can also customize your in-app and email Notification settings across all subscriptions.
André Arnaud de Cal... 291,228 Super User 2024 Season 2
Martin Dráb 230,056 Most Valuable Professional
nmaenpaa 101,156