How to configure chunk file for Microsoft GP Webclient.

(0) Share

Report

Posted on by Community Member

Hi,

I am new to Microsoft GP, I have installed chunk file and my form is appearing on microsoft GP but its not appearing in web client. Do i have to configure it seperately if yes then how?

Thank you

Shah

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (1)

Suggested answer

Beat Bucher GP Gee... 28,058 Moderator on at

Like (1)

Report

Well...

it depends, but probably your full GP client is not running off the same location than the Web client does.. in which case the launch file from the Web client wasn't updated with your 'chunk' file..

Find out where your Web Client services are hosted and find out which launch file it is using (DYNAMICS.SET or similar).

The Web client launch file isn't necessary identical as the full 'fat' client, since some 3rd party products are not working with the Web Client.. Typically the WC launch file will be 'lighter' than the fat client.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Thanks for your reply sir, where to check for dynamics.set file ? i browse the folder location where service is deployed and didn't find such file. should this be defined in some configuration?

Was this reply helpful? Yes No
Verified answer

Beat Bucher GP Gee... 28,058 Moderator on at

Like (0)

Report

Sorry,

I don't have a functional Web client right now..

The information came on top of my head from a past setup I had done for GP 2013, though the principles haven't changed much for the newer releases.

Hint: 1. determine from the URL of the web client where it's hosted

2. Check the local Dynamics GP folder under Program Files (x86) on that server..

3. Look for a file with extension .SET

Was this reply helpful? Yes No
Suggested answer

MG-16101311-0 26,225 on at

Like (0)

Report

To make things easy, your chunk file should be deployed EVERYWHERE where Dynamics GP is installed.

Was this reply helpful? Yes No