Microsoft Dynamics AX (Archived)

Unit of measure for time conversion is not defined

(0) Share

Report

Posted on by Community Member

Hi All,

I have a Sales Event Kanban and I receive the above mentioned message when I try to post it.

BR,

Michalis

*This post is locked for comments

I have the same question (0)

All responses (14)

Answers (0)

Suggested answer

Ludwig Reinhard Microsoft Employee on at

Like (0)

Report

Hi Michalis,

Please check and complete the setup of your unit conversions in the organisation admin module under Setup - Units - Unit conversions.

Best regards,

Ludwig

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Ludwig,

Actually regarding items I use only one UoM for all of them (which is unit). So I do not understand why conversion is required.

BR,

Michalis

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Ludwig,

as I noticed now the message refers to time conversion. However I checked Organization administration->Setup->Units Conversion and time conversions are there.

BR,

Michalis

Was this reply helpful? Yes No
Community Member on at

Like (1)

Report

Hello Michalis

please show all error message

first line is concerned with conversion but I think that clue is in second line when you have no default unit

Best regards

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Tomasz,

please see below

Thanks,

Michalis

Was this reply helpful? Yes No
Suggested answer

Ludwig Reinhard Microsoft Employee on at

Like (1)

Report

Hi Michalis,

Please check the setup under:

Production control - setup - production control parameters - lean manufacturing tab and then what units are setup in the production flow section (Qty and time).

Best regards,

Ludwig

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Ludwig,

Qty: TEM

Time: Hr

this is the printscreen

BR,

Michalis

Was this reply helpful? Yes No
Suggested answer

Ludwig Reinhard Microsoft Employee on at

Like (2)

Report

Hi Michalis,

The error message is actually only triggered from an incomplete setup of the production parameters.

Can you check that everything is also setup in the other parameter tabs especially the unit of measure tab.

Can you also let us know whether the parameters shown above have already been set before you started your production or did you just set them up recently?

Best regards,

Ludwig

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Ludwig,

the parameters were set before I started production.

Thanks,

Michalis

Was this reply helpful? Yes No
Ludwig Reinhard Microsoft Employee on at

Like (0)

Report

Hi Michalis,

If you start a 'fresh' production, does the same error message pop up?

Seems a bit tricky to identify the underlying cause of the problem here.

Yet, please try running the consistency check in the system admin module to see whether this Feature gives you some additional hints on missing setups.

Best regards,

Ludwig

Was this reply helpful? Yes No