Hi all,
My end users only have read access to customers, so when they run the Customer Statement Report they were getting errors as the report updates "Last Statement No." on the Customer Card.
As a work around I copied the original report (Report 1316 Statement) and created my own just adding the permissions, so they don't get that error. I then updated "Report Selection - Sales -> Customer Statement" so that way clicking on the "Statement" Button will run the report.
THE ISSUE: Literally everything else is working properly except the filter "Customer No." doesn't pull the correct Customer number. (See below I was on customer# 10010, but it pulled up 1052).
Important Notes:
- 1052 is the last customer I ran the report for so I'm assuming it's using the last saved values.
- As far as I've spot tested this behavior (filter Customer No. is the last used Customer No.) is consistent for every single Customer except customer number 10000 (I have no clue why this one is different).
Thank you!
Share
Report
All responses (
Answers (
1,589
