Ribbon workbench 20166 Button DisplayRule\OptionSetRule

(0) Share

Report

Posted on by Community Member Microsoft Employee

I want create some Logic for showing/hiding button using DisplayRule\OptionSetRule

It definitely doesn’t work. Apparently problem is in comparing of StateCode’s value. I tried to use “No”, “no” - Doesn’t work. Button doesn’t display.

When I set InvertResult to true, button displays but problem is that in tested case StateCode is equal to 0

*This post is locked for comments

All responses (5)

Answers (0)

CrmMad 65 on at

Like (0)

Report

RE: Ribbon workbench 20166 Button DisplayRule\OptionSetRule

Thank You MANIKANTA CRM for resolve the problem, because I've been searching how to do and anybody have explained how to associated
Community Member Microsoft Employee on at

Like (0)

Report

RE: Ribbon workbench 20166 Button DisplayRule\OptionSetRule

here i used JS in enable rules to hide button based on my scenario
Community Member Microsoft Employee on at

Like (1)

Report

RE: Ribbon workbench 20166 Button DisplayRule\OptionSetRule

Hi we have to configure Enable rules in RW to show/hide button in form and that enable rule has to be attached with command and command has to be used with button.
Suggested answer

Nithya Gopinath 17,074 on at

Like (0)

Report

RE: Ribbon workbench 20166 Button DisplayRule\OptionSetRule

Hi Peter,

Try using the FormStateRule instead of OptionSetRule.

See the links below.

https://community.dynamics.com/crm/f/117/t/153867

http://raju2565.blogspot.in/2014/11/form-state-rule-using-ribbon-work-bench.html
David Jennaway 14,063 on at

Like (0)

Report

RE: Ribbon workbench 20166 Button DisplayRule\OptionSetRule

The OptionSetRule is designated as Internal use only, so you may not be able to make it work. What are you trying to achieve ? If you want to display a button based on the record's statecode, then you could use a FormStateRule