How do I write to a batch job log?

(0) Share

Report

Posted on by Community Member

I have made a modification to a batch job and need to confirm that the parameter it uses are correct so I have echo'd the parameter using the Info function. After the job has completed clicking on Log gives nothing. Does the Log only display errors? I have replaced Info with Warning and Error but there is still no output to view.

How can I output and retain messages associated with a batch job?

*This post is locked for comments

I have the same question (0)

All responses (6)

Answers (0)

Mea_ 60,284 on at

Like (0)

Report

RE: How do I write to a batch job log?

You can try to go to batch task inside of batch job and check log there.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

RE: How do I write to a batch job log?

Yes I've tried that but it's the same result - nothing.

Was this reply helpful? Yes No
Mea_ 60,284 on at

Like (0)

Report

RE: How do I write to a batch job log?

What about batch job history, did you set "save job history = Always" ?

Did you do CIL after your changes ?

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

RE: How do I write to a batch job log?

Yes it was set to Always. I hadn't generated an Incremental CIL but have just done that and the result is the same.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

RE: How do I write to a batch job log?

You can try to reset user data and run the batch again.

Note:

Before doing so, make sure you don't have any important data which will be lost.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

RE: How do I write to a batch job log?

I tried that but it makes no difference.

If I run the batch interactively my trace messages are displayed in an infolog. I can't see why it's so hard to get these into the batch log.

Was this reply helpful? Yes No