6
Hi,
I am looking to setup a unit of measure when used, then it will multiply the unit cost by quantity and a conversion factor to get to the total line amount. In the example below the conversion factor is 0.001
Is there a way to setup this in D365?
*This post is locked for comments
I have the same question (0)
Hello Sam,
If I get you right then you want to 'abuse' the unit conversion for price calculation purposes. Rather than doing that can't you simply setup a price of $23.25 per 1000 units delivered?
That is, your price is actually 886900 * $23.25/1000 = $20620.43
This price specification should do the job.
Best regards,
Ludwig
Share
Report
All responses (
Answers (
