Printer Ez3844 - T-3000 plus

(0) Share

Report

Posted on by Community Member

Hi. We are trying to print customized price labels in RMS with printer T-3000 plus. We have a lot of merchandise to print labels for its (example 120 ítems 3 each for a total of 360 labels) . We follow all the process in RMS and when appear "congratulations" in the screen, then the preview only shows one label of the first ítem. The size of the label is 1" x 1". Do we need to change the printer? Previously we used MS Dinamics POS 2009 software and don't have problems.

*This post is locked for comments

All responses (2)

Answers (0)

Suggested answer

Community Member on at

Like (0)

Report

RE: Printer Ez3844 - T-3000 plus

RMS is by default setup to use avery label sheets, multiple labels per 8.5 by 11 page.

But you can design a label that prints one per page, but it takes some trial and error. So it depends on your labels. But might require you to use the label designer to alter the height, width and margins.

If you are using a roll of labels then most likely each label is as wide as the roll, which previews in the Label Wizard as one per page. You can use the next page button to preview the next label. Try printing a single label, and if that works then print a few at the same time.

You should not have to change the printer.
Community Member on at

Like (0)

Report

RE: Printer Ez3844 - T-3000 plus

I would recommend you first determine if you can print stock labels using this printer. Customized for POS 2009 may not work with RMS Samuel.