Installing GP 2018 with MSI

(0) Share

Report

Posted on by Community Member

We are trying to use the MSI and SCCM but we keep getting the following error message: The installation does not have a native interface.

Have you seen this error before? Do you have any insights on how we can use the GreatPlains.msi with SCCM for our upcoming GP 2018 Go Live? We have over 50 users and, as you can imagine, our DBAs are looking for the most efficient install approach.

Thank you in advance for your assistance.

*This post is locked for comments

I have the same question (0)

All responses (5)

Answers (1)

Verified answer

Needles 80 on at

Like (0)

Report

I found this link - community.dynamics.com/.../72207

Hope it helps

Was this reply helpful? Yes No
Tim Wappat 5,711 on at

Like (0)

Report

For others finding this thread in the future, you can also look on the GP media for the Powershell modules that allow you to install and configure GP via Powershell that are essentially a admin friendly front end to the .msi installers.

Was this reply helpful? Yes No
DavidMO 1,030 on at

Like (1)

Report

Also for those looking in the future, I dug in and developed dos batch scripts for GP Client installs and many of the 3rd party plug-ins.

Last used for GP 2018 R2 they save me a lot of time and I recouped my research time many times over.

Reach out to me on GPUG if you would like copies.

Was this reply helpful? Yes No
BrianHarry 52 on at

Like (0)

Report

Can you please send me copies of the commands you used to install GP 2018

Kind regards

Brian

Was this reply helpful? Yes No
Suggested answer

DavidMO 1,030 on at

Like (0)

Report

Here I clipped my steps and reference material from several sources into a Word document. There is a sample batch script listed at the end of the document.

Your mileage may vary. Good luck!

David Morinello

Dynamics-GP-Silent-Install-Documentation.docx

Was this reply helpful? Yes No