Report as finished Journal - Item doesn't have unit sequence group id error

(0) Share

Report

Posted on by Community Member

Hello All,

I am using production orders in AX 2012 R3. After the "start" phase of production order I am using Report as finished and I am getting below error and still status showing as "start".

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (0)

Sort by

Suggested answer

Ludwig Reinhard Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi,

Have you checked your item setup especially the units assigned for inventory transactions, etc.

Best regards

Ludwig

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

Hi Ludwig,

Yes I checked my items and all items are assigned with "ea" unit.Few items are controlled by SiteWHLoc and few are SiteWh.

Best Regards,

Sai Rajesh

Was this reply helpful? Yes No
Suggested answer

Ali Alkhateeb 97 on at

Like (1)

Report
Copy link

Link copied!

hi Saj,

If you are using advanced warehouse management in your configuration, you have to setup "Unit sequence group" located in released products under warehouse management tab.

Please refer to below link for Set up a unit sequence group and unit of measure conversions.

technet.microsoft.com/.../dn553191.aspx

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

Hi Ali,

It is not a advanced warehouse item and item is controlled by SiteWHLoc.

Thanks.

Regards,

Sai Rajesh

Was this reply helpful? Yes No