Hi,
I have a requirement where the item is measured in eaches, cases, cartons, and pallets. I have defined a unit sequence group and assigned it to the item. I have also defined unit conversions.
In my location directives, I have defined rules for each unit of measure.
For example, if the work unit is a pallet or case, it should pick from the "reserve" location; if the work unit is cartons or eaches, it should pick from the "picking" location.
Now, when I create a sales order for 170 units, it should ideally create two pick lines: one for 1 IC and one for 10 eaches. However, the system is creating a single pick line with 170 eaches.
Please let me know what needs to be done to make this work.
Please note that I have tried "allow split" option on location directives and it was of no help.
I have added setup screenshots below
