Supply chain | Supply Chain Management, Commerce

Wave not assigned/Work not created after Releasing SO to warehouse

(1) Share

Report

Posted on by RyanNeill

Hi there,

I have been following the outbound transport end to end guide whitepaper and am at the point where I have validated my load and have released it to warehouse but when I view the wave details everything is blank.

I have set up my wave template, work template and location directives all to the relevant warehouse. As per another discussion on the community on this topic I removed the location on my location directives as it was said that D365 will use the location linked to the item.

Wave Template:

4454.Wave-Template.PNG

Work Template:

2627.Work-template.PNG

Location Directive (Pick/Put):
4520.Pick.PNG 6521.Put.PNG

I have looked at location directive failures and there are no records and am not sure where the problem could be

Many thanks

I have the same question (0)

All responses (5)

Answers (0)

WillWU 22,363 on at

Like (1)

Report

Hi RyanNeill,

Did you check the old thread and follow the suggestion:

community.dynamics.com/.../388166

community.dynamics.com/.../389642

Was this reply helpful? Yes No
Suggested answer

asedawy 119 on at

Like (1)

Report

Hello

check the load posting methods form under setup in warehouse management module if the methods are not generated then generate them.

hope this helps

thanks

1 people found this reply helpful.

Was this reply helpful? Yes No
Suggested answer

Gaurangkumar Jani 4,534 User Group Leader on at

Like (0)

Report

Hi RyanNeill,

Are you using "Batch" Tracking dimensions?

If yes, Please enable Batch in Location directive action.

Let us know if this helps,

Thanks,

Was this reply helpful? Yes No
RyanNeill 37 on at

Like (0)

Report

Hi there, The load posting methods have been generated

Was this reply helpful? Yes No
RyanNeill 37 on at

Like (0)

Report

Hi there, The tracking dimensions are set to 'None' as per the guide.

Was this reply helpful? Yes No