You’re offline. This is a read only version of the page.
Announcements
Hi Everyone,
You can see from the below snapshot, I enter the 'Amendment notification' via the Revision 'change notification' to control the revision, but I can't add the record/line in the red box shown in the below snapshot. If I click 'create BOM', there's no response. If click line to also create the record in the red box, I get some errors as the below snapshot.
Does someone have this experience? You can give me suggestions, guideline, introduction...Any help regarding this is welcome & appreciative. Thanks.
*This post is locked for comments
I have the same question (0)
Share
Report
All responses (
Answers (
3
