web
You’re offline. This is a read only version of the page.
close
Skip to main content

Notifications

Announcements

No record found.

News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Microsoft Dynamics RMS (Archived) / Barcodes printed from ...
Microsoft Dynamics RMS (Archived)

Barcodes printed from RMS not working

(0) ShareShare
ReportReport
Posted on by Muktadir Khan 130

Hi

 I imported some products from my old POS system.  They have labels that have been printed on the old system with barcodes and they now correspond to the lookup codes.

I tried to add some new stock today and printed off the labels but they are not being scanned by my scanner.  I have tried all the barcode options and no joy.

 The barcodes are printed with a Dymo.  My scanner is a Metrologic Voyager and will read all other barcodes that I have tried.  I am just having no luck with the barcodes printed in RMS.

 Any suggestions?

 

Thanks

*This post is locked for comments

I have the same question (0)
  • David Kelly Profile Picture
    David Kelly 285 on at
    Does the scanner beep at all when you scan the “rms bar codes”? if not then try editing the Label Design, and make the barcode object a little longer. This will increase the spacing between the bars in the bar code, and make it easier to scan.
  • Betty Rabe Profile Picture
    Betty Rabe 20 on at

    Ours is completey new retail store so no legacy codes out there. 

    I am having the same problem.  I have shortened the barcode number and that didn't work.  I also tried printing one from the Dymo using the Dymo software with my numbers and that didn't work.  BUT, if I print a generic label from the Dymo printer - that works.

    I am at a total loss here.  Any suggestions at all would be helpful.

  • Muktadir Khan Profile Picture
    Muktadir Khan 130 on at

     Hi Betty

     Try making the code really short "T1" for example and set it to 128A as the barcode type.

     When you create the label to print, don't create  a new label, use an existing template and edit that so it the same size as the Dymo label.  The important thing I found here was not to change the size of the barcode object as that caused an issue

     Also near the bottom of the label designer wizard you can change the option from Twips (huh?) to cm and that made adjusting the labels easier :)

     How long are you lookup codes as of right now?  I found that more than about 7 caused it go wrong.

    Let me know how you get on.

     

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Responsible AI policies

As AI tools become more common, we’re introducing a Responsible AI Use…

Neeraj Kumar – Community Spotlight

We are honored to recognize Neeraj Kumar as our Community Spotlight honoree for…

Congratulations to the November Top 10 Community Leaders!

These are the community rock stars!

Leaderboard > 🔒一 Microsoft Dynamics RMS (Archived)

Last 30 days Overall leaderboard

Featured topics

Product updates

Dynamics 365 release plans