Supply chain | Supply Chain Management, Commerce

Warehouse utilization report

(8) Share

Report

Posted on by AH-07052021-0

157

Hi All,

I am trying to run the warehouse monitoring report for warehouse utilization.

I am not maintaining the dimensions at Location profile

but I have my warehouse location dimensions and volume - I am not seeing system calculate the Available Volume, current volume and Max volume automatically.

How can I get the system to calculate those values and show up.

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (4)

Answers (0)

Suggested answer

Laurens vd Tang 3,879 Super User 2025 Season 2 on at

Like (0)

Report

Good day,

I believe you need to configure the location dimensions in the location profile

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No
AH-07052021-0 157 on at

Like (0)

Report

I tried both :

Still my locations showing empty:

Was this reply helpful? Yes No
Suggested answer

Laurens vd Tang 3,879 Super User 2025 Season 2 on at

Like (0)

Report
Good day,

Could you check if the following parameters have been enabled?

Enable location status

Enable item in location

Enable location activity date/time

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No
Suggested answer

Sagar Suman 6,550 Super User 2025 Season 2 on at

Like (1)

Report

Hi,

The Max volume on the location form is for data purpose only and is not calculated. You can use the field to update the Max allowed volumes and track the current volumes on tiles.

Available Volume - Calculated based on Location profile setup for dimensions

Current volume - Calculated volume of items stored on the location

Max Volume - Manual entry field for data control and analysis

Was this reply helpful? Yes No