Announcements
No record found.
I am trying to receive a PO via eConnect, but am receiving an error message stating the PO Line Number does not exisit for this PO, even though it does.
*This post is locked for comments
Hi Mike
Are you sending the POLNENUM value to the schema? Are you sure that value match your PO?
Yes Nancy, I am doing both. The schema was working fine until I added the POLENUM value. I had to do this becuase the particular PO had items on more than one line.
I see
I have an econnect integration that does this, I send the POLNENUM value, the VNDITNUM and the RCPTLNNM.
The POLNENUM is the value on the ORD field (POP10110 table), VNDITNUM is also from that table. The RCPTLNNM is a value that increase on 16384 for every line.
Do you have this in your code?
I did not but have added and am still getting the same results
Could you post the XML or your code? and also, the error points to a certain line? Did you check that line is not closed or canceled in your PO?
OK, I figured this out. In table PO10110 there is a field called "LineNumber." I was using this for the value for POLNENUM. However the line number needed is found in the ORD field.
Exactly, as I said, the value for POLNENUM is the ORD value.
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Congratulations to our 2026 Super Stars!
Thanks to all of our 2025 Community Spotlight stars!
These are the community rock stars!
Stay up to date on forum activity by subscribing.
