Microsoft Dynamics CRM (Archived)

Portal request timeout when opening a specific web form

(0) Share

Report

Posted on by Patrick Friedrich

395

Dear all,

we are having issues in configuring the CRM Portal due to an unknown error as the title says.

Already tried to reproduce the webform and put it again on the web page but still not working. It seems that the webpage is fine but as soon as we include the form it bugs.

Also cleared the cache, set portal off/on etc.

Did you see a similar issue when opening a specific page or form and it tries to load for like a minute without responding?

Is there any setting you can switch in the wrong direction by accident? We have something like a business process to capture data in different steps using one custom form.

Any clues / ideas / help much appreciated.

Patrick

*This post is locked for comments

I have the same question (0)

All responses (5)

Answers (2)

Verified answer

RaviKashyap 55,410 Moderator on at

Like (0)

Report

Hi Patric,

The unknown error can occur due to various different reasons. refer the below blog link on the same issue which has some suggestions-

community.dynamics.com/.../274141

There is also a link to enable portal logging for more details.

Hope this helps.

Was this reply helpful? Yes No
Suggested answer

Mahendar Pal 45,095 on at

Like (0)

Report

HI,

You can also see error when form is customized but not published, so if you have done any changes to the form make sure it's published, also make sure you are able to open that form from CRM without any error.

Was this reply helpful? Yes No
Patrick Friedrich 395 on at

Like (0)

Report

Thanks for the given input, but I couldnt find the issue yet. Does the picture help in any way?

Should I just check my custom entity? It consists of 5 different steps until it ends.

Thanks

Patrick

Was this reply helpful? Yes No
Suggested answer

RaviKashyap 55,410 Moderator on at

Like (0)

Report

Hi,

Can you check if you have added any field more than once on the form/ tab you has used in your web form. If yes, remove the field and try again.

Was this reply helpful? Yes No
Verified answer

Patrick Friedrich 395 on at

Like (1)

Report

Found it - it was a configuration setting which wasnt set correctly.

In the form form steps you can choose next and previous step. By accident we choose the same lookup step for both which doesnt make sense for sure.

Normally I would expect an error here, because the cannot be the same in my mind.

Thanks for you feedback anyway!

Was this reply helpful? Yes No