Management Reporter: Can you migrate selected reports only?

(0) Share

Report

Posted on by Community Member

Hi,

I ran the migration wizard and migrated all the reports successfully. As I was fixing errors, I found out that MR is missing some reports from FRx - I think I accidentally deleted them. Is there any way to import one or two reports from FRx and not the entire data set?

Also, if I run the migration again through the wizard, does it delete all definitions exist in MR before running the migration?

Thank you in advance!

*This post is locked for comments

All responses (2)

Answers (2)

Verified answer

Ian Grieve 22,784 on at

Like (0)

Report

RE: Management Reporter: Can you migrate selected reports only?

Migration Wizard is an all-or-nothing migration, but as Soma says you could export the building blocks already in Management Report, migrate and then reimport the ones you exported.

However, if the missing building blocks were not migrated last time then they are likely to fail to migrate again.
Verified answer

soma 24,410 on at

Like (1)

Report

RE: Management Reporter: Can you migrate selected reports only?

I think, we can not migrate the selected reports from FRx to MR.

If you run the migration again, it will remove the existing building blocks from MR. So, export all the reports building block from MR and save. Then run the migration wizard FRx to MR. After migrated the FRx reports, just import the MR building blocks which you have saved.

Hope this helps!!!