Announcements
I have installed Microsoft Dynamic CRM 2015 at my localhost, local server that is accessible to me.
I want to updagrade my CRM version from 2015 to CRM 2016.
I started doing so,
In Settings > Administration > Product Updates
after filling all necessay fields, and logging in. I have to face this error message again and again.
Is there any solution? thanks.
*This post is locked for comments
Thanks Guido, just had same issue, with a development.
Yes I found this setup file and setup is running now, But set up is asking to type 25 characters of Product Key.
Is there any valid key for developers?
I start setup and Product Key information page is shown.
How to install this setup for trail of 30 days?
is this possible?
Yes I found this setup file and setup is running now, But set up is asking to type 25 characters of Product Key.
Is there any valid key for developers?
how to go ahead of this thing...
one thing that I would like to ask that as if I already have installed CRM 2015, and I should go to install CRM 2016 from scratch
did you mean this one?
I did so, but in this case an error message occurs, that permissions not allowed where it is going to install..
much confusing.
Thanks.
ok, but I am to upgrade CRM 2015 to CRM 2016. as I have already installed CRM 2015.
@Guido Preite
Dear while applying the solution, I again stuck at this point.
please guide me.
I found installation directory and following is a clear picture where I stuck,
what is meant by Server\amd64, why not Server/amd64 if it were a folder at this location.
Thanks.
I have only local server, and CRM and SQL Server both are installed on this one only.
#1
Mohamed Amine Mahmoudi
83
Super User 2025 Season 1
#2
Community Member
54
#3
dkrishna
6
Share
Report
All responses (
Answers (
