The value 205 is not found in the map.

Question Status

ARPIT CHAVHAN asked a question on 15 Jun 2014 9:54 PM

Dear all,

I have created a separate module. I have also created parameter table for the same and now I am trying to create a number sequence tab in it.

Steps I followed is as follows-

1) created an EDT.

2) Created an enum with the new module in NumberSeqModule

3) Created a NumberSeqModule<ModuleName> class with loadmodule and number seq module methods.

4) Created a job to load this module.

5) now when I open my parameter form I am facing with the error

"The value 205 is not found in the map." 205 is the enum value of numberseqmodule enum.

I don't know where I got wrong. Please suggest something.

Thanks & Regards.

Martin Dráb responded on 15 Jun 2014 10:28 PM

The first step is looking at what code is throwing the error, i.e. analyzing the call stack.

You can add a breakpoint to Info.add() - it will be called when putting the error message to infolog and you'll see the call stack in the debugger.

If the problem doesn't become obvious, please post the call stack here.

Jagadis Sahu responded on 10 Jul 2014 4:39 AM

Hi All,

Any get through from this issue. because i have faced the same issue.

kindly help.