When i add a new customer or vendor into the vendor /customer form i am receiving the below error message.
system doesnot support setup 'continuous' of number sequence address.
Number selection is canceled.
I set up manual number sequence for both vendor / customer account.
Look forward to hearing from you.
Prompt reply is highly appreciated.
Thanks
Mubarak Sha
Saudi Arabia.
*This post is locked for comments
perfect mstrillian...it worked as i wanted to use the continuous number sequence.
You need to put a ttsbegin/ttscommit statement around your number sequence generation code if you want to use a continuous number sequence. Continuous number sequences allow you to release unused numbers back to the pool of number sequences to use. Decide first if you want/need a continuous number sequence and then make it work. Unchecking the 'continuous' number sequence checkbox will work, but it may not be the final solution that you need.
Hello ,
Thank you so much for your speedy response. Appreciated.
Yes. It works. I did the same yesterday before i installed rollout 7 for Ax2009 service pack 1.
but i did not not check your solution after install this.
Thanks again...to bring to my attention this valuable knowledge.
anybody wants to apply this solution please make sure the following version.
Kernel version and application version: 5.0.1500.4570 . AX.2009
Try unmarking the continous check box for address book number sequence
Go to DAT/Organization administration/Common/Number sequences/Number sequences
#1
André Arnaud de Cal...
292,884
Super User 2025 Season 1
#2
Martin Dráb
231,760
Most Valuable Professional
#3
nmaenpaa
101,156
Moderator
Share
Report
All responses (
Answers (