Skip to main content

Notifications

Announcements

No record found.

Dynamics 365 Community / Blogs / DaxGeek / Add Elements to the Canvas

Add Elements to the Canvas

To add elements to the canvas, follow these steps:

1. From the
Workflow editor form select the desired node in theWorkflow elements pane on the left.

2. Drag and drop the element onto the
Canvas. The element can be
repositioned on the canvas by dragging and dropping it again.


3. Each workflow element must be connected in the correct sequence.
This is done by hovering over the "starting" element with your
mouse and then clicking one of the connector points. With the mouse
button held down, drag the mouse pointer to the "next" element.
Release the mouse button when you have hovered over one of the
connector points on the "next" element.


4. Repeat steps 2 and 3 for each desired element.


TIP: Each workflow configuration has a Start node and an End node by default.
The first action should always connect from the
Start node to the desired node,
and the last step should always connect from the desired "last step node" to the
End node.

Regards,
Hossein Karimi

Comments

*This post is locked for comments