Allow "Register Downtime" - Production Floor Execution

(2) Share

Report

Posted on by JeanB

208

Hello everyone, I’m working with D365 Dynamics F&O and need some guidance.

How can I enable the Register Downtime button in the Production Floor Execution module?

The goal is to track machine downtime with a reason, such as a machine stopping due to a lack of materials.

I believe the correct button to use is Register Downtime rather than Break, but it’s currently disabled, and I’m not sure how to activate it.

Any help would be greatly appreciated!

Capture d’écran 2...

Your file is currently under scan for potential threats. Please wait while we review it for any viruses or malicious content.

Categories:

Dynamics 365 Project Operations

Dynamics 365 Finance

I have the same question (0)

All responses (6)

Answers (1)

Verified answer

Jonas "Jones" Melgaard 4,988 Most Valuable Professional on at

Like (2)

Report
Copy link

Link copied!

Hi JeanB,

Downtime is registered on the machine, not the job, which might indicate a missing link to asset management.

Unfortunately, I don’t read French, so I’m unable to understand the captions on the two tabs in the form. Could you provide an English translation?

Was this reply helpful? Yes No
JeanB 208 on at

Like (0)

Report
Copy link

Link copied!

Hello,

Thank you very much for your response, and I apologize for any language issues.

I now understand that the downtime is linked to a machine, so I added the Machine tab, and I can successfully register the downtime on the machine set as an Asset.

I have a follow-up question: Is it possible to link the downtime to the Work Order (specifically, the fabrication work order associated with the job that was active at the time of the downtime)?

Thank you in advance for your help!

Was this reply helpful? Yes No
Jonas "Jones" Melgaard 4,988 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Sounds good, and hey no worries! We resolved it, that's all that matters 😊

If it's okay, can you check my reply as an answer?

To answer the follow up question.

No, not out of the box (speaking of production and route job, don't want to confuse with an asset work order). I don't recall having seen this, and I cannot see that it's done looking at the code that's responsible for assets.

Was this reply helpful? Yes No
JeanB 208 on at

Like (0)

Report
Copy link

Link copied!

Thank you a lot for your help Jones !

For the other question, I'll start another question. Have a good weekend !

Was this reply helpful? Yes No
DL-13121122-0 14 on at

Like (0)

Report
Copy link

Link copied!

@JeanB, could you expand your explanation please. I have the same problem.

Thank you.

Was this reply helpful? Yes No
Suggested answer

CA Neeraj Kumar 5,002 on at

Like (1)

Report
Copy link

Link copied!

Hi @DL-13121122-0,

Here the solution used by @JeanB is:

1) Navigate to Configure Production Floor Execution

2) Click on Design tabs

3) Add a new tab name and main view as "My Machine" In details view, select "Job Details"

4) Add required actions that you want to see.

5) Add the tab under Tab selection.

Regards,

NK

Was this reply helpful? Yes No