Reject vendor request

(0) Share

Report

Posted on by Community Member

After the vendor request (vendor add justification workflow) is rejected the workflow status says request rejected but there is no option to re-submit the workflow for approval again.

*This post is locked for comments

I have the same question (0)

All responses (5)

Answers (0)

Sort by

OsmanIstanbul 2,820 on at

Like (0)

Report
Copy link

Link copied!

hello Swathi.Achhu,

can you recall workflow and try again?

best regards!

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

Hi Osman,

The vendor request status is “Request rejected” where as the workflow status in workflow history is “completed”.so I don’t have the option to recall the workflow

Was this reply helpful? Yes No
OsmanIstanbul 2,820 on at

Like (0)

Report
Copy link

Link copied!

Hi

Are you able to cancel workflow? Status must be draft to re-submit.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

No, I cannot cancel it too.. other than view history I do not have any option.

Was this reply helpful? Yes No
MB-27040951-0 2 on at

Like (0)

Report
Copy link

Link copied!

We have a similar issue with Proposed vendor changes, if they have been rejected, status is Changes rejected, but we cannot submit new changes, only get workflow history option, not submit.

Same for approved changes, it wont let us submit new changes...

No option to cancel, resubmit or recall.

Did you find a solution?

Thanks

Mie

Was this reply helpful? Yes No