Notifications
Announcements
No record found.
Hello,
I installed AX 2012 R3 with CU10 in sleepstream, but the axbuild file is not present in the directory where it usually is.
Any ideas of the reason?
Thank you in advance
*This post is locked for comments
Hi Agostino,
You mentioned you created a slipstream installation. Which exact version of AX was used for the base setup which was extended with the slipstream?
Hi André,
I don't know why but it is a R2, I was sure I downloaded the R3.
Thank you.
Why did you remove the contents of the question?
Hello André,
This is what I also thought this morning. In fact I was sure that I installed the R3, but it was the R2.
Thank you
I added it again.
Thanks. Now other persons can also follow the thread and learn from it. Too bad the R2 and R3 images were mixed. It was my first thought so I asked you the question to verify it.
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
As AI tools become more common, we’re introducing a Responsible AI Use…
We are honored to recognize Neeraj Kumar as our Community Spotlight honoree for…
These are the community rock stars!
Stay up to date on forum activity by subscribing.
Martin Dráb 4 Most Valuable Professional
Priya_K 4
MyDynamicsNAV 2