Share
Report
210Hello everyone,
A question about the decimal management in Dynamics 365 F&O.
The problem is that I have two attributes : the Width and the Thickness. Both are measured in millimeter, BUT the differents is on the decimal number :
- Width has 1 decimals, like W = 30,5 mm
- Thickness has 4 decimals, like th = 4,5580 mm
As the decimal number is managed at the Unit level, I must creat my millimeter unit with 4 decimals :
And with that, the Width as 4 decimals, which is a bit ridiculous:
Do you have a solution to be able to have 1 decimal on the Width and 4 on the Thickness ?
Thank you,
I have the same question (0)
All responses (
Answers (
