The debugger for Microsoft Dynamics was not found. Install the debugger

(0) Share

Report

Posted on by Community Member

Dear Experts,

Today I faced very odd error "The debugger for Microsoft Dynamics was not found. Install the debugger" when tried to complete stock status change from "Blocking" to "Available" for one of the RAW materials via emulator.
In our TEST environment everything seems to be working fine (Copy of Production environment last weeks)
Any suggestions what could possibly cause the issue?
Regards,
V

*This post is locked for comments

I have the same question (0)

All responses (3)

Answers (2)

Verified answer

Chaitanya Golla 17,225 on at

Like (1)

Report

Hi,

Usually, this message appears when some kept the breakpoint and it's been hit. So please check if you have any breakpoints enabled, with the help of breakpoint window(command: "Shift + F9") and also for the keyword "breakpoint". Hope this helps you.

Thanks,

Chaitanya Golla

Was this reply helpful? Yes No
Verified answer

Vilmos Kintera 46,149 on at

Like (1)

Report

Other than having a hard or soft breakponit as Chaitanya has mentioned, there could be Debug::assert() calls which would also trigger opening the debugger. If those are being hit, that typically means a fatal condition has occurred in data or setup.

Try removing all breakpoints first, then if it does not help, run the client from a computer where debugger is installed and see where does it stop (most likely an assertion).

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Thanks Chaitanya & Vilmos
Regards,

V

Was this reply helpful? Yes No