Using Http for Nav Integration

(0) Share

Report

Posted on by Fritz Camille

580

Hi,

I am trying to configure the connector for Nav 2017 CU6 with CRM 2016 (8.2) On premise. In Nav, when setting the connection using the http://CRMserver address I receive an message: The application is set to support secure connections (HTTPS).

Would anybody know where I need to go to deactivate this option in Nav? My CRM does not have an https address.

2664.Capture.JPG

Thank you

*This post is locked for comments

I have the same question (0)

All responses (1)

Answers (0)

Aric Levin - MVP 30,190 Moderator on at

Like (0)

Report

I am not sure if this is an option that you can disable, but this would be a question for the NAV group.

The requirement of SSL has been pretty standard lately (although HTTP still supported), and both Online and IFD use ADFS for authentication.

Try posting this in the NAV group and see if you get any response there.

Good luck...

Was this reply helpful? Yes No