web
You’re offline. This is a read only version of the page.
close
Skip to main content

Announcements

Introducing our New Video Series: Community Spotlight
News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Microsoft Dynamics AX (Archived) / How can i solve System...
Microsoft Dynamics AX (Archived)
Answered

How can i solve System Does not support setup continuous of number sequence address.

(0) ShareShare
ReportReport
Posted on by Mubarak Sha 195

When i add a new customer or vendor into the vendor /customer form i am receiving the below error message. 

system doesnot support setup 'continuous' of number sequence address. 

Number selection is canceled. 

I set up manual number sequence for both vendor / customer account. 

Look forward to hearing from you. 

Prompt reply is highly appreciated. 

Thanks

Mubarak Sha

Saudi Arabia.

 

 

*This post is locked for comments

I have the same question (0)
  • Verified answer
    640579632b5c4e6780a624c4771b6f93 Profile Picture
    640579632b5c4e6780a... 4,730 on at

     

    Try unmarking the continous check box for address book number sequence

    Go to DAT/Organization administration/Common/Number sequences/Number sequences

  • Verified answer
    Mubarak Sha Profile Picture
    Mubarak Sha 195 on at

    Hello , 

    Thank you so much for your speedy response. Appreciated. 

    Yes. It works. I did the same yesterday before i installed rollout 7 for Ax2009 service pack 1. 

    but i did not not check your solution after install this. 

     

    Thanks again...to bring to my attention this valuable knowledge. 

    anybody wants to apply this solution please make sure the following version.

     

    Kernel version and application version: 5.0.1500.4570 .  AX.2009

     

     

  • Suggested answer
    mstrillian Profile Picture
    mstrillian 282 on at

    You need to put a ttsbegin/ttscommit statement around your number sequence generation code if you want to use a continuous number sequence. Continuous number sequences allow you to release unused numbers back to the pool of number sequences to use. Decide first if you want/need a continuous number sequence and then make it work. Unchecking the 'continuous' number sequence checkbox will work, but it may not be the final solution that you need.

  • Vinay Singh Profile Picture
    Vinay Singh 30 on at

    perfect mstrillian...it worked as i wanted to use the continuous number sequence.

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

News and Announcements

Introducing our New Video Series: Community Spotlight

Quick Links

Season of Sharing Community Challenge Launch!

Jump in, show your community spirit, and win prizes!

Women in Power Builds Momentum

Expanding mentorship, skilling, and AI innovation

Congratulations to the May Top 10 Community Leaders

These are the community rock stars!

Leaderboard > 🔒一 Microsoft Dynamics AX (Archived)

#1
Sanhthosh.Kumar.K Profile Picture

Sanhthosh.Kumar.K 2

#2
Raed Salah Bzour Profile Picture

Raed Salah Bzour 1

Last 30 days Overall leaderboard

Featured topics

Product updates

Dynamics 365 release plans