Cycle counting WHS app error - "Product or variant is not on the order"

(0) Share

Report

Posted on by Do_Mart

Hi everyone,

I am facing a problem with the WHS mobile device app: the sequence of the steps in the process is scan the item and than enter the counted quantity for that item,but after the first iteration the system shows the enter value for the previous item without letting the user to continue with the scaning for the next item,and when the same value is enter again the error "Product or variant type not in the order" appears. As I can see in the code while debugging it seems like the map "pass" is not removing the value #ProductConfirmation and showing it again and again. Is anyone facing the same issue? Any help would be greatly appreciated. Thanks.

I have the same question (0)

All responses (4)

Answers (0)

Sort by

SunilRatna 82 on at

Like (0)

Report
Copy link

Link copied!

Hi,

I'm currently facing this issue also when using product confirmation. Have you had any insight as of yet? Would be much appreciated.

Was this reply helpful? Yes No
AdamCarri 35 on at

Like (0)

Report
Copy link

Link copied!

Hey all,

I'm also getting the same error on the mobile app. My Item is a product master with variants. L/M/S Sizes. not sure how to get around this error message? it doesn't occur for standard products that don't have variants.

thank you

Was this reply helpful? Yes No
SunilRatna 82 on at

Like (1)

Report
Copy link

Link copied!

I think we got around this issue as the variants did not have the bar code setup. To do this, navigate through to:

Product information management -> Products -> Released products

Under Manage stock click on Bar codes

You can then create unique barcodes for each variant. It's also key to note here once the barcode is generated for the variant product, you will need to select General from the top and then enable scanning/printing parameters (see screenshots below).

Let me know if this works for you!

Was this reply helpful? Yes No
Green_oop_North 113 on at

Like (0)

Report
Copy link

Link copied!

I tried the suggestion from SunilRatna below, we were getting the same message when picking and confirming the item code.

This creates a unique variant number which then becomes the barcode. Using copy and paste function, with access to the client, we were able to paste in the unique variant number to the mobile device when confirming the item, it's important to note though that the mobile device always displays the Item code and not the new variant number so not sure how you can get around this?

Also, you'll need to find a way of presenting the new variant number (which is the barcode) on your inventory for scanning purposes.

Was this reply helpful? Yes No