POS "Operator ID is not valid"

(0) Share

Report

Posted on by Community Member

Hi,

We have installed dynamics ax(Dynamics AX 2012 R3 demo. When We start the POS, it is asking to enter Operator ID and Password. I try to log in with the internal number of a worker but the message "Operator ID is not valid" appers.

Please advice

*This post is locked for comments

I have the same question (0)

All responses (2)

Answers (1)

Verified answer

Rodolfo Recalde on at

Like (1)

Report

Hi Michalis,

I do not remember exactly, but I think the default password for VM is:

OperationID: 000160
Password: 123

Either way, you may need to configure the operationId for specific tests and studies. Follow the instructions described by me and Mauro at this link.
Basically you need to set up the employee for the store in question, the POS permissions and synchronize this information to the store DB.

I Hope this Helps!

Regards,

Rodolfo Recalde.

Was this reply helpful? Yes No
Community Member on at

Like (1)

Report

Yes it works!

Was this reply helpful? Yes No