delete re-add data source from form

(0) Share

Report

Posted on by maxhammer

Hi, Guys

Remove from a form CustTable datasource CustTable. Then added again. But now the form CustTable does not behave correctly. Click on a client from the list, swears that is not specified client id, etc.
Can you please tell how to fix this problem?

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (2)

Verified answer

Community Member on at

Like (0)

Report

This bad practice to do this kind of activity

I Assume you have done this USR layer.

so I suggest you should delete the USR layer of the CustTable Form and then compile the form

I hope this will solve the issue which you are having.

please verify and update if this helps you

Was this reply helpful? Yes No
Verified answer

Denis Macchinetti 16,444 on at

Like (0)

Report

Hi Maxhammer

Erasing the datasource, all form controls linked to it, have lost the "Datasource" property.

This is the reason because the custTable form don't work properly.

If you have done many customizations, I suggest you to use the last backup or last version if you have the Version Control enable.

Another workaround, could be compare the form at the current layer with the below layer and delete the customizations created with the Datasource deleting.

Finally, as partially suggested by Nitesh, backup the current form, delete the current layer and comparing the form with the Backup XPO, restore your customizations.

Was this reply helpful? Yes No
maxhammer on at

Like (0)

Report

thanks Nitesh and Denis))) I think, better delete from user layer.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

appreciated if you please mark the post as verified if posts are useful

Please help

Was this reply helpful? Yes No