Hi
I have a question about number sequence settings with WHS.
When I receive the item with WHS portal I obtained the error message below.
=======================
System does not support setup 'continuous' of number sequence xxxxx. Number selection is canceled.
Assign dimensions to LP
=======================
Why AX WHS does not allow to use continuous? How can we get through this?
Thank you,
*This post is locked for comments
Hi Tom.
Ievgen is correct here. Some additional note: Usually only invoice numbers and vouchers do have a requirement to be continuous. Other sequences may have gaps unless there is a legal requirement to have a sequence continuous.
Hi Tom T,
Continuous number sequences should be allocated inside a transaction in x++, probably this one is not. To fix this issue just remove "continuous" tick box on this number seq. It could be found under "Organization administration > Common > Number sequences > Number sequences".
Generally you should avoid continuous number seq because they have performance impact unless there is legal requirements.
#1
André Arnaud de Cal...
292,575
Super User 2025 Season 1
#2
Martin Dráb
231,493
Most Valuable Professional
#3
nmaenpaa
101,156
Share
Report
All responses (
Answers (
