Hi everyone,
I try to connect our IOM with the Inventoy visibility service that is already configured and connected with a D365 F&O system.
The provider in IOM for IV was already configured succesfully.
But basically I can't select the additional calculated measures that are configured in the IV on the IOM side.
We configured entity version 2 therefore some of the registers in IOM show the following message /The current entity version is 2. changes from this page will not work.
Please got to Settings(Preview) Section: Feature Management Page to edit the configuration./
Is this just for information? Does IOM support Version 2? Or shall we use version 1?
Is their perhabs futher information or a howto/whitepaper concerning the basic setup of IV in IOM? Or a presentation that I miss? In the IOM documentation I found only the setup of the provider, the prerequisits, the JSON described and the short flow example. I already checke the documentation for IV itself.
Thanks a lot for tips and hints.
Kind regards,
Sven
2
Share
Report
All responses (
Answers (
