You’re offline. This is a read only version of the page.
334
Hello,
We have a P&L report that uses a tree. We would like the Top Level Summary unit to report summary lines and the remaining units report detail lines.
I understand you can only have 1 Row Definition defined in the tree and use the Financial Dimensions link to set this up. I setup an FD2 for the Summary lines and FD1 remains the detail lines.
I checked the "Use row definition from the reporting tree" checkbox in the Report Definition, however the Top Level Summary continues to report the detail.
I found the article below. It seems this can be done.
*This post is locked for comments
I have the same question (0)
Hello,
This is from our management reporter specialist in regards to the above post:
It sounds like they have a row definition that has ‘summary’ rows, and a row definition that has ‘detail’ rows. They want to use the ‘summary’ row definition for the summary node of a reporting tree, and the detail row definition for the other nodes of the tree. I don’t think they can do that. If I test this in MR, I cannot enter different row definitions on the nodes of a reporting tree. If I change the row definition on any of the nodes, it changes it for all nodes on the tree.
Best Regards,
Jana
Share
Report
All responses (
Answers (
