Finance | Project Operations, Human Resources, ...

Unable to activate database logging

(1) Share

Report

Posted on by Gaute K

322

I am trying to activate database logging on the period status for the ledger calendars.

However, as you can see in the last picture below, the /Finish/ button is greyed-out, so I am not able to activate the tracking.

Any suggestions?

I have the same question (0)

All responses (3)

Answers (0)

Sort by

André Arnaud de Cal... 305,182 Super User 2026 Season 1 on at

Like (0)

Report
Copy link

Link copied!

Hi Gaute,

In my environment the button is enabled. This regardless if I used your setting, another setting, or no setting at all. Can you check if you have a message when you open the Database log setup form? You can also try to run the consistency check from this form which will reset and enable all database triggers.

Was this reply helpful? Yes No
Suggested answer

Kevin Xia Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi,

I did it according to your settings and it did cause the finish button to be disabled and not clickable, and there was also a warning error, do you have this error on your page?

Best regards,

Kevin

Was this reply helpful? Yes No
Suggested answer

Venkatram Reddy 9 on at

Like (1)

Report
Copy link

Link copied!

You must click "Clean up log" link on the wizard, on the next screen setup a recurrence job to clear the logs with iteration 1 time, click OK to continue. try to keep the schedule for this recurrence only in the next 5 min. This action will clear the DB logs if already exists. and a fresh copy of the logs will be inserted to the table with the current user who is running this wizard now. This is a list kind of master on which tables, fields the logs were already enabled. after this step you will see the 'Finish' button enabled.

Note that , this will not delete any of the logs those were already recorded on transactions, those were enabled already.

1 people found this reply helpful.

Was this reply helpful? Yes No