Barcode handheld device for NAV

(0) Share

Report

Posted on by Community Member

Hi All,

My client wants to use handheld device for stock take. I have done setup barcode code on Item card --> Item Cross reference --> Cross reference type is barcode --> input barcode number into field "Cross reference no."

Then from sales line, I place mouse arrow at Cross-Reference No. --> scan item --> then nothing come out.

Please advise do i need to do any NAV configurations before using barcode device.

Thanks all.

*This post is locked for comments

I have the same question (0)

All responses (7)

Answers (1)

Suggested answer

Amol Salvi 18,698 on at

Like (0)

Report

Check whether barcode scanner scanning the barcode or not

Just try like this Open notepad and scan the barcode from product using scanner and check whether it is displaying the value

Was this reply helpful? Yes No
Suggested answer

Maneesha 5,891 on at

Like (1)

Report

what is you Barcode handheld device ?

did you change the Barcode scan mode to : "Always Scan"

Was this reply helpful? Yes No
Verified answer

Indikauk 1,759 on at

Like (1)

Report

Hi Vovnnha

1st check the Barcode Scanner is working properly or not, to check it just open the Notepad and try to scan the Item and see whether it is printing the number on the Notepad.

If it is Printing then there is no problem with the scanner & drivers you need to look into Navision in this case.

If it is not printing then you need to verify things with the barcode scanner and driver issue etc.

Thanks

Indika.

Was this reply helpful? Yes No
Suggested answer

Maneesha 5,891 on at

Like (0)

Report

i think its better to check 'indika' said

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Thanks Maneesha. It is.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

I have installed driver again and reset all setting. It works now. Thanks Indika

Was this reply helpful? Yes No
Suggested answer

Maneesha 5,891 on at

Like (0)

Report

refer your scanner Guide book , there some capture code/bar code that you can change the scanning mode

Was this reply helpful? Yes No