Hi All,
I've run into an issue with the setup for Inventory movement after Purchase Order receipt and I'm hoping someone has already found the solution for this.
At the moment we use separate mobile device menus for PO Line Receipt and PO-PutAway to receive to a default location (Receipt) and then PO-PutAway to allow assignment of pre-printed LPs and organization of the received goods to 2 different staging areas depending on the product. This works excellently, but now the hard part!
I had planned to use Inventory Movement by Template to move the goods to their final storage locations but have run into the following issue:
1. After combining two similar products onto one LP during Put to the staging location, when I try to use inventory movement to put that LP into it's final location, AX requires that I enter each item ID on the LP and put them away separately - Instead of using the location directive I had intended (AKA Multisku).
After reading through the responses to the issue, it seemed like directive codes may have been the answer. However, from what I can see I can't assign Directive codes to an inventory movement work template. And to make things worse, I can only use 1 directive code on the mobile Device menu setup which stops me from differentiation there as well.
The goal here is to be able to use inventory movement by template to put away goods based on a number of different location directives depending on the items.
GuyUK, any ideas on this one? You're response back in 2015 (https://community.dynamics.com/ax/f/33/t/139366) gave me hope, but they were dashed upon realizing this was intended to a single bulk area rather than multiple possibilities.
Happy to post more relevant info if needed, just let me know.
Thanks in advance for any suggestions !
Cheers,
S
