BOMDesignerForm does not show BOM for the specified BomVersion

(0) Share

Report

Posted on by dark_knight

942

Hello,

I go here - DAX/Product information management/Common/Released products

and then click on the tab Engineer. There I go to BOM -> Designer (BomDesigner form is opened then) and for some ItemIds this designer doesn't show a BomVersion's ItemIds in the BomTree Control although the BOmVersion exists and has got ItemIds inside. I tried to put breakpoint to BomDEsigner form according to event method sequence when a form is opened but I still do not get why for this itemid BOM for BOMVersion is empty.

Can you pls help me to get where to dig to?

Thanks.

I have the same question (0)

All responses (2)

Answers (1)

Verified answer

Community Member on at

Like (0)

Report

In the Setup page, there are some criteria which you should check.

Was this reply helpful? Yes No
dark_knight 942 on at

Like (0)

Report

Hello,

Yes. You are right. in the table inventItemSetupSupplyType field DefaultOrderType should be either ReqPOType::Production or ReqPOType::Kanban for the itemid which we see in the form above. After setting this up somewhere in the system everything works fine.

Was this reply helpful? Yes No