Notifications
Announcements
No record found.
Hi,
I would like to show the vendor ID in MR. By looking in the column definition, ATTR , the list of the book code doesn't have the vendor ID.
Any idea?
Thanks
*This post is locked for comments
Hello Sam K.
Please check: GL-LedgerSetup-Financial Reporting Setup - Attributes Tab and make sure that the parameters available are active.
Once they are, then the vendor attribute should become available.
(Might require a restart of the MR processes).
Best regards,
Ludwig
Thank you! Is it available in AX 2012?
Hi Sam,
Yes, this is also available in AX2012 but for AX2012 it depends a bit on the Version as it has been available, was then taken out and became available again.
Please check the following sites
blogs.msdn.microsoft.com/.../adding-vendor-and-customer-to-a-dynamics-ax-report-management-reporter-cu6
dynamicsaxtips.wordpress.com/.../advanced-management-reporter-attributes-add-missing-attributes-to-management-reporter
Great. Thanks!
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
As AI tools become more common, we’re introducing a Responsible AI Use…
We are honored to recognize Neeraj Kumar as our Community Spotlight honoree for…
These are the community rock stars!
Stay up to date on forum activity by subscribing.
Martin Dráb 4 Most Valuable Professional
Priya_K 4
MyDynamicsNAV 2
