1,645
Suddenly out of nowhere I received below message when running certain reports
"object of type page with id 10077 could not be found"
Any suggestions will be appreciated.
*This post is locked for comments
Alex,
It is not the pages, it is the report request page i am not sure how can one can create a page in that number range, that range is locked by the microsoft and nobody can use it and there is no localization which uses those pages.
It is the report itself which is causing the issue, open the object metadata table and filter for the type report and delete all the records, and then compile all the reports. One other way is it is may be time consuming but compiling all the objects would be best.
either pages 10075-10077 are missing or it's a object metadata problems.
you could solve that by editing table object metadata and delete all records refering reports 10075-10077. then recompile the reports, restart nav service and try again.
Is a good point Jonathan, unfortunately the error varies depending the report. I got the same problem when running report#10076. The message is similar but with different number.
Ex. When running report 10077 report says": Object of Type Page with id 10077 could not be found.
When running report 10076 the error message says: Object of Type Page with id 10076 could not be found.
that's typical for go lives. after working for some time with the new system one or more problems occur, because not all functions/objects are used and no system is completely tested when golive starts.
so check the old database, if there is a form 10075. it seems that a page with id 10075 is needed, but only if you activate Loginteraction in request form of the report. you can either never use that flag, remove all references of page 10075 or recreate form 10075 as new page in the new database.
as i mentioned before, it's a migrate/upgrade issue.
it means that form 10075 in old nav 3.7 database was not upgraded to the new nav 2013 database. it's needed that you create a new page with object id 10075 as replacement with the same fields and code.
when upgrading replace COUNTAPPROX by COUNT.
#1
André Arnaud de Cal...
292,516
Super User 2025 Season 1
#2
Martin Dráb
231,436
Most Valuable Professional
#3
nmaenpaa
101,156
Share
Report
All responses (
Answers (
