Hi All,
I am not sure if I found an issue or not.
I would like to use new credit management functionality because I need a workflow for approving credit holds.
I set in parameters 2 checking points: confirmation and release to warehouse.
I set also that credit limit type is All+Balances and Message...as Warning.
When I try to confirm a sales order I have a meesage from "old" functionality that credit limit exceeded open balance but when I click "ok" on confirmation posting - the sales order will be put on hold because the new functionality will work.
However, having the same parametrization and starting from the begining, when I try to release to warehouse - only message about exceeded credit limit will be displayed and the sales order will be not put on hold.
It means that when I select "release to warehouse" as a check point it would be impossible to use new functionality with credit limit exceeding, because the following message will block further analysis and credit managements will not run at all.
On the other hand I cannot switch this message off because I would have to change credit type to No but it applies to all credit management as well.
Any suggestion how to solve this problem?
