Finance | Project Operations, Human Resources, ...

ER - can't find models created in accounts receivable parameters for other configuration providers

(0) Share

Report

Posted on by D365FO user

465

So i created a new model in ER where it's linked to a configuration provider that is active (not Microsoft)-- inside it there are no repositories. i'm not sure if this is the issue

I did datasource mapping and i also created the format and changed status to completed

but when i go to accounts receivable, i can't find it

I have the same question (0)

All responses (12)

Answers (0)

Ludwig Reinhard Microsoft Employee on at

Like (1)

Report

Hi D365FO user,

Can you share some screenprints that illustrate the setup and the issue?

Many thanks,

Ludwig

Was this reply helpful? Yes No
D365FO user 465 on at

Like (0)

Report

Hi Ludwig,

Was this reply helpful? Yes No
Alireza Eshaghzadeh 14,686 Super User 2025 Season 2 on at

Like (0)

Report

Hi D365FO user,

What is configuration component of CustInvoice on ER config?

Was this reply helpful? Yes No
D365FO user 465 on at

Like (0)

Report

Hi Alireza,

what do u mean by configuration component? where can i find that?

Was this reply helpful? Yes No
Alireza Eshaghzadeh 14,686 Super User 2025 Season 2 on at

Like (1)

Report

You can find it on ER config that you have created.

Was this reply helpful? Yes No
D365FO user 465 on at

Like (0)

Report

here it is

Was this reply helpful? Yes No
Suggested answer

Alireza Eshaghzadeh 14,686 Super User 2025 Season 2 on at

Like (0)

Report

All custom models created at ER configs cannot be used in accounts receivable parameters > Electronics document. Make sure that you have created the custom config derived from "Invoice model"

Was this reply helpful? Yes No
D365FO user 465 on at

Like (0)

Report

Hi Alireza,

1. But what if i want to create my own invoice model? Can i edit the invoice model? Where i remove things and add things?

2. And where else can i use my own custom model if i can't edit the parameters... So i can 't use my own custom model to send invoices to share point? Or send them anywhere?

3. If you have time please, can u check this link and help me in solving the relations

community.dynamics.com/.../1069702

Was this reply helpful? Yes No
Suggested answer

Alireza Eshaghzadeh 14,686 Super User 2025 Season 2 on at

Like (0)

Report

Hi D365FO user

Your question is broad so I cannot address it completely.

Generally, I you want to create a custom config that can be used for e-invoice, you can install the standard config from LCS (D365FO workspace > Electronic reporting > Microsoft > Repositories > LCS > Open).

Then you can create a new model mapping where you can create modification by adding elements, change mapping, create mapping ect.

For example, I have created the following mapping for interest note. I have created a mapping for interest note that can be sent electronically.

Please check the link on how to create model mapping on ER Config from Microsoft:

https://docs.microsoft.com/en-us/dynamics365/fin-ops-core/dev-itpro/analytics/general-electronic-reporting

Could you please verify this feedback as if my suggestion was helpful.

P.S.This feedback is my own opinion.

Was this reply helpful? Yes No
D365FO user 465 on at

Like (0)

Report

Hi Alireza,

I created a new model under InvoiceModel i also created a new mapping. However when i want create tho format derived from peppol so that i can see it in AR parameters, inside the format Mapping i still see the original model even though i specified when creating the format my new model

Was this reply helpful? Yes No