When consulting the commands bar relative to the leads view, i found out that there is more than one qualify command as shown in the attached screenshot .
So my question is: why are there repeated qualify commands and what does each of them serve for ?
The buttons are all OOB, there are some rules that Microsoft has implemented to show them only when necessary.
To identify which one is enabled in your case, use ribbondebug.
Regards, Jimmy Passeti | Microsoft MVP ✅ Please mark as Verified if this answered your question!
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
10
Share
Report
All responses (
Answers (
