Hi Experts,
Need your help. I am new with this kind of error.
The prompt says I need to specify the Inventory Posting Group when I check on the Item List of the part# it already have the Invt. Posting Group. which is PART. but still the error appears.
I have attached here screenshot for your reference.
Thanks in advance.
Regards,
*This post is locked for comments
Hi Experts,
Thank you all for your answers. Since, i cannot delete the transaction in designer object what I did is that
i undo the shipment and delete/cancel the service order and advise the service advisor to create a new one.
Best Regards,
Beth
Ideally, you should never edit/delete any ledger entry through Object Designer. You should reverse to entry to nullify the posted effects.
And with respect to Open Service Order, make sure Inventory Posting Group exists on the Item before selecting on Order Line else you will need to re-select the line again on the Order.
-Yogesh Kulkarni
Please verify, if you find answer helpful.
You should not delete the Item ledger entry as it will make your system vulnerable and there will not be any relation.
It is not recommended at all. If you entries are wrong then reverse those entries but not delete.
Hi,
May I know what is the effect if I delete a line in Item Ledger Entries through Designer Object?
Regards,
Bibeth
For entering the inventory posting group in open service order
1) If it is one service order then you can delete the line and reenter again
2) If you want to update in several service order then you need to write small program to update the same.
Thank you all for your answer.
I have populated the service order and found out that there is no Inventory Posting Group
and I think it is in the setup of Vehicle. I go to the Vehicle Menu and search the VIN the Inventory Posting Group is already exist in Vehicle Card.
How can I add the Inventory Posting Group in open Service Order?
Thanks very much.
Bibeth Guittap
You might have attached inventory posting group to item after entering line in transaction. Kindly zoom by using Ctrl +F8 and check whehter inventory posting group populated on line
If not then delete the line and reenter again
Did you add it now or it was already there?
Please remove the line and add again.
If you have entered the inventory posting group after entering the line on the order then it will not reflect the order, you need to delete the line from the order and re-enter the line on order again.
#1
André Arnaud de Cal...
292,516
Super User 2025 Season 1
#2
Martin Dráb
231,403
Most Valuable Professional
#3
nmaenpaa
101,156
Share
Report
All responses (
Answers (
