4,156
Hello Folks,
I am trying to setup the 'system preferences' here and even though I have updated the SY04920 Table manually with the active user's profile, it will still put the old profile which is even inactive.
I wonder where it is embedded and how to update/replace it?
Yes, leave it blank and it will automatically insert by itself the next time you log in.
Here is an article for how to run on MFA.
https://docs.microsoft.com/en-us/dynamics-gp/whats-new/multi-factor-authentication
Blog about Basic Authentication being turned off on Oct 1, 2022:
Hope that helps,
Cheryl
Dynamics GP Support
Hi Nicole,
Thank you so much for your reply. I did delete the record but then I also inserted. should I leave it blank and let the GP re-create it by itself?
Also, I can't the find place to enable MFA. Please advise
Hi Szars,
Thank you for your post. You could try and remove this record from the SY04920 table. The record should be re-created on the next successful login to Exchange via GP.
I did also see that you do not have MFA enabled yet, with the Basic Authentication going away in October, I would strongly encourage this gets implements to avoid any emailing disruptions.
Dynamics GP Email Troubleshooting Guide - Dynamics GP | Microsoft Docs
I hope this helps, please let us know how it goes.
Nicole Sutton Post
Senior Support Engineer
Microsoft Dynamics
Share
Report
All responses (
Answers (
