Problems Debugging Batch Server

(0) Share

Report

Posted on by lispyj

201

I am trying to debug a batch job on a AX2009 SP1 Server running on Windows 2003. The batch is running the BomCalcJob class from the dialog. I have followed the instructions on the step by step debugging found here http://blogs.msdn.com/b/x/archive/2009/06/25/step-by-step-checklist-for-debugging-batch-jobs-in-dynamics-ax.aspx, but I haven't had success. Here is what I have done so far, Set the Server configuration for debugging, set My client configuration for debugging, logged on using the service account, set the breakpoints, opened the debugger and submitted a batch. I have not run the patch for Windows 2008. I have tried the same steps using the client installed on the AOS. I have moved my breakpoint around to make sure that I am catching active code. Any ideas would be appreciated.

Thanks,

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (0)

Sort by

640579632b5c4e6780a... 4,730 on at

Like
a
(0)

Report
Copy link

Link copied!

try writing a breakpoint;

Was this reply helpful? Yes No
lispyj 201 on at

Like
a
(0)

Report
Copy link

Link copied!

I have set several breakpoints

Was this reply helpful? Yes No
Suggested answer

EduardoAndres 1,080 on at

Like
a
(0)

Report
Copy link

Link copied!

Take a look at this.

axwonders.blogspot.com/.../debug-x-code-in-batch-server-in-ax-2009.html

Was this reply helpful? Yes No
lispyj 201 on at

Like
a
(0)

Report
Copy link

Link copied!

Thanks for the link. I have done all of the configuration steps on the email. I did notice, however, that a batch group is required. I do not have a specific batch group defined, so that may be my issue. I will check it out when I can.

LJ

Was this reply helpful? Yes No